$0.120/min
+594 · 34 routes
Country code +297
Aruba VoIP rates
Prepaid SIP termination to Aruba from $0.120 per minute across 13 published prefix routes and 3 operator groups. Rates effective July 16, 2026.
Lowest fixed-line rate$0.120/min
Lowest mobile rate$0.120/min
Billing increment1/1
Rates effective2026-07-16
Increments in use on Aruba: 1/1 (13 routes). Displayed values are source “from” rates; billing increments, traffic type, route availability, KYC and commercial margin all affect the final customer offer.
Operator breakdown
Aruba routes by network
| Route | From | Up to | Increment | Prefixes | Example prefixes |
|---|---|---|---|---|---|
| Fixed | $0.120 | — | 1/1 | 1 | +297 |
| Mobile | $0.120 | — | 1/1 | 7 | +29756, +29759, +297600, +297622, +29766, +29769, +29799 |
| Mobile Digicel | $0.120 | — | 1/1 | 5 | +297630, +297640, +297641, +29773, +29774 |
Connecting
How to call Aruba from your platform
Dial Aruba numbers in E.164 format: country code +297 followed by the national number, with no local trunk prefix, spaces or brackets. Most platforms expect digits only; some require a leading plus. Confirm the exact dial pattern during testing.
CloudyVoice works with any SIP-capable endpoint — softphones, IP desk phones and ATAs, IP-PBX platforms such as Asterisk, FreeSWITCH and 3CX, call-centre dialers including ViciDial, and VOS softswitch deployments. Authentication is by SIP registration or approved IP address.
Before sending production traffic to Aruba, test across several networks in the destination and check two-way audio, caller ID behaviour, post-dial delay, answer supervision and billing. The route-quality guide explains the method.
Questions
Frequently asked questions
How much does it cost to call Aruba over VoIP?
CloudyVoice publishes Aruba termination from $0.1200 per minute, with fixed-line routes from $0.12 and mobile routes from $0.12. These are source “from” rates across 13 prefix routes; final pricing depends on your traffic profile, volume and quality requirements.
What is the country dialling code for Aruba?
Aruba uses country code +297. Dial in E.164 format — the country code followed by the national number, without a local trunk prefix, spaces or brackets.
Why are mobile rates to Aruba different from fixed-line rates?
Mobile termination in Aruba carries a fee set by the receiving mobile operator, separate from the fixed-line network. That is why the cheapest mobile route here is $0.12 while the cheapest fixed route is $0.12. Each mobile operator range is priced individually, so the prefix you dial determines the rate.
What billing increment applies to Aruba calls?
The most common increment on Aruba routes is 1/1. Written as first/subsequent, 60/60 bills whole minutes, 60/1 bills the first minute in full then per second, and 1/1 bills per second throughout. On short calls the increment affects effective cost more than the headline rate.
Which devices can I use to call Aruba?
Any SIP-capable endpoint: softphones such as Zoiper, MicroSIP or Linphone; SIP desk phones; analog phones behind an ATA; IP-PBX platforms including Asterisk, FreeSWITCH and 3CX; call-centre dialers such as ViciDial; and VOS softswitch deployments. Both username/password registration and IP authentication are supported.
Do I need an account to see Aruba rates?
No. Every rate on this page is public. An account is needed only to send traffic, and outbound routes are enabled after traffic review confirms your destinations, expected volume and lawful use case.
Ready to call Aruba?
Create an account, complete traffic review, and top up from $10. Every Aruba rate above is published before you register.